Autostart AS-1795 - Manual (Page 5)

If Swap Start Mode is selected, to remote-start your vehicle press lock and unlock
simultaneously. The aux 2 output can be activated by pressing the start button.
Installer-programmable Valet Modes
Valet Mode Using the Valet Switch
When your vehicle is in Valet Mode, the remote starter functionalities are disabled. If the vehicle
needs to be serviced, or if you park it indoors, the Valet Mode will prevent the engine from being
remote-started accidentally.
To put the system i n t o Valet Mode:
• Turn the ignition key to the ignition on ( run ) position.
• Within 3 sec., press the valet button
The parking lights will flash 3 times
• Turn the ignition key to the OFF position
The L.E.D. will come ON solid.
To take the system out of Valet Mode:
• Turn the ignition key to the ignition on ( run ) position.
• Within 3 sec., press and release the valet button
The parking lights will flash twice and the L.E.D. will come OUT.
Note: Once Valet Mode is activated, the remote starter will be disabled.
"Home Valet^ M " Mode
If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if
the vehicle is parked indoors there is no danger of it starting accidentally by remote control.
Note: Once the Home Valet Mode is activated, the vehicle will not start by remote.
To take the system i n t o Home Valet Mode:
Press the lock or unlock button.
Within 3 seconds, press the stop button until the Parking Lights go out
To take the system out of Home Valet Mode:
Turn the ignition key to the ignition on ( run ) position.
The system will warn you if someone attempts to start your vehicle while it stands in Home Valet
Mode. The parking lights will:
Go on then off ; then
Flash twice, pause; then
Flash twice again.
Turbo Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
is shut down by remote control), then shut down the engine and set the Remote Car Starter to
Ready Mode.
To activate Turbo Mode, follow all steps of the Ready Mode routine:
1. Ensure that all the doors are closed and that the shifter is in the neutral position.
2. With the engine already running, apply the parking brake and
Make sure to release the brake pedal.
release the brake pedal.
3. Within 20 sec. press lock , unlock or start
The parking lights will flash 3 times quickly and remain lit.
on the transmitter.
4. Remove the key: the engine will go on running.
5. Exit the vehicle and close the door.
6. Press and hold either:
P. 8 User Guide
Remote Starter Features
Idle Mode
Convenience feature: Idle Mode allows you to keep the engine running and the doors
locked while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running. For example, if you stop for a delivery or at a conveni­
ence store, lock your vehicle and leave it running for the length of a run cycle while you are away.
The engine will go on running until the user re-enters the vehicle or until the expiration of the
Engine Run Time.
Idle Mode can be activated through the same routine as that used for Ready Mode; at the last step,
the trunk button is pressed instead of the other buttons:
1. Ensure that the doors are all closed and that the gearshift lever is in the NEUTRAL
position.
2. With the engine already running, apply the parking brake and release the brake pedal.
Make sure to release the brake pedal.
3. Within 20 sec. push lock , unlock or start on the transmitter.
The parking lights will flash 3 times quickly and remain lit.
4. Remove the key: the engine will go on running.
5. Exit the vehicle and close the door.
6. Press the trunk button until the system is armed (the doors will be locked if remote
door lock is installed).
If the pre-programmed run-time expires or if the user shuts down the engine by remote control, the
vehicle will get in Ready Mode.
Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.
Valet Mode
When your vehicle is in Valet Mode, the remote starter functionalities are disabled. If the vehicle
needs to be serviced, or if you park it indoors, the Valet Mode will prevent the engine from being
remote-started accidentally.
Ignition Valet
This feature will allow you to remotely put your system into Valet Mode by using the ignition key
instead of the Valet button as above. Ignition Valet can be used without a Valet button installed.
User guide P. 5