Bogen CPT-1A - Manual (Page 2)

TO PLAY A CASSETTE TAPE
The door of ihe CPT lA is hinged and will open and
close with the insertion and removal of the cassette.
1. Rotate the power ON/OFF/VOLUME switch
clockwise and increase volume slightly.
2. Check cassette to be certain that the tape is
tightly wound on the reels.
3. Insert the narrow end of the cassette into
receptacle, with exposed tape toward the right.
When the cassette is fully inserted it will
automatically begin to play (the unit will switch
from radio to the tape player mode).
4. When the tape reaches Uie limit of Its travel, the
CPT^IA will automatically reverse direction and
play the opposite side of the cassette. You may
manually reverse direction of play at any time by
pressing the PROG button.
5. a. To advance tape rapidly, press FF/EJ, a two
position switch, slowly until it locks into the
first position.
b. To rewind tape rapidly, press PROG, then
FF/EJ slowly until it locks into the first posi ■
tion.
c. To discontinue either of the above and
return to normal operation, press and release
FF/EJ.
6. To remove the cassette, firmly press FF/EJ-to the
second (EJECT) position.
IMPORTANT NOre
Always remove the cassette from the CPT-IA
after use to prevent damage to the cassette
and tape drive mechanism.
FM/AM OPERATION
1. Rotate the power ON/OFF/VOLUME switch clock ■
wise and increase volume slightly.
2. Select either FM or AM radio band by pressing
AM/FM button.
3. Select desired position of the MO/ST mode switch.
4. Rotate tuning Imob to locate the desired radio fre-
quency as indicated on frequency scale.
ROirriNE MAINTENANCE
Periodic cleaning of the tape head, capstans, and pinch
rollers will ensure high quality reproduction of
program material and tioublc-free operation. The unit
should be clean«l every 20 to 30 hours of operation.
Use of a good quality cassette cleaning cartridge is
recommended; if one is not readily available, proceed
as follows:
1. Saturate a cotton swab with isopropyl (rubbing)
alcohol.
2. While holding the cassette door open, locate the
tape head (to the right of the opening and toward
the center of the unit).
3. Clean the tape head, capstans, and pinch rollers
with the cotton swab.
4. Allow parts to dry before operating the unit.
OVERLOAD PROTECTION
The CPT-IA is protected by an internal 100mA, slow
blow fuse. If this fuse opens, the unit will shut down
completely:
have the trouble investigated by a
qualified technician.
CAtrnON
There are no user-serviceable parts within the
unit. To avoid an electric shock hazard, have
all internal servicing performed by qualified
service personnel only. The warranty will
become void if repairs are made by other than
the Bogen Service Department or authorized
service agency.