Assembly instructtons, Handleassembly, Loose hardware and tools – Bolens 117-670-300 User Manual
Page 3: Lower handle assembly, Handle panel assembly, Upper handle assembly, Note
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY INSTRUCTtONS
HANDLEASSEMBLY
1.
Remove
the
loose
hardware
from
the
assembly
pack.
You
will
need
a
screwdriver
and
a
5/16"
wrench, either a socket as shown in figure 1 or an
open end wrench.
2.
Assemble the lower handle to the handle brackets
as shown in figure 2.
3.
Secure
the
handle
with
cotter
hairpins
on
both
sides. See figure 2.
4.
Place the handle panel over the lower handle and
fasten with the handle panel screw using a 5/16"
wrench. See figure 3.
5.
Place the upper handle over the lower handle and
line up the holes as shown in figure
4.
6.
insert the curved head bolt from the inside and
tighten the knob by hand. See figure 4.
7.
Place the throttle control in the handle panel and
assemble
it
with
the
two
throttle
screws
using
a
screwdriver. See figure 5.
8.
Use the cable clip to fasten the throttle control wire
to the lower handle.
9. Check ALL nuts and bolts for correct tightness.
FIGURE 1.
LOOSE HARDWARE AND TOOLS
FIGURE 2.
LOWER HANDLE ASSEMBLY
FIGURE 3.
HANDLE PANEL ASSEMBLY
FIGURE 4.
UPPER HANDLE ASSEMBLY
FIGURE 5.
THROTTLE CONTROL ASSEMBLY
NOTE
It may be necessary to spread the ends
of
the
lower
handle
outward
slightly
to assure a snug fit against the bracket
mounting area.