Black & Decker 9013 - Manual (Page 6)

Bubble Level
Your drill is equipped with a bubble level
that assists you in drilling level holes.
For horizontal drilling, tilt the drill up
or down as required so that the bubble
floats in the center of the parallel lines
drawn on the glass.When the bubble is
centered between the lines, as shown in
Figure 1, the drill is level.
For vertical drilling, align the drill so
that the bubble floats in the center of the
bull's eye, as shown in Figure 2.
To assure accuracy, first place a
level on your workpiece and position the
piece so that it's level. Then, when the
drill reads level, the two will be aligned.
(Any level can only indicate level with
respect to the earth's gravitational field.)
NOTE: The level is filled with
mineral oil that may cause minor skin or
eye irritation when contacted. If the level
breaks and the fluid gets on your skin,
rinse thoroughly with water. If the liquid
gets in your eyes, rinse thoroughly with
water and contact a physician immedi­
ately.
SCREWDRIVER BIT
RELEASE BUTTON
Bit storage
A double ended (#2 Phillips and
Straight) screwdriver bit is included with
your drill. The bit stores in the drill handle,
as shown in Figure 3. To remove the bit
from the handle, hold the drill normally
and depress the button shown in Figure 3.
The bit will drop out of the handle. To
reinstall into handle, simply push it into
the hole as far as it will go. (You may have
to twist it slightly in order for it to go all the
way in.)