Bolens 137-360-300 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

FIGURES.
FIGURES.
1- Place steering shaft pinion in steering gear
and fasten with two hex sems bolts. A Vz”
wrench is required. See figure 4.
3. Place the other tube clamp on top of steering
shaft and secure with four hex screws and hex
iocknuts. Two 7/16” wrenches are required.
See figure 6.
FIGURES.
2. Place one tube clamp under steering frame.
See figures.
4. Assemble the hood with long truss screws to
the rear of hood, and the short truss screws to
the front of hood. Fasten with lockwashers
and hex nuts to the tnside. See f igure 7.
This manual is related to the following products: