Bolens 413R - Manual (Page 3)

ASSEMBLY INSTRUCTIONS
CAUTION
Please note that the chute deflector on
your mower is in an upright position.
It is held in that position by a shipping
block. This block is used for shipping
purposes only. It must be removed and
discarded before your mower is put
into operation.
Chute Deflector
Shipping Block to be Removed
HANDLE ASSEMBLY
1. Remove the loose hardware from the assembly
pack. You will need a screwdriver and a 5/16"
wrench, either a socket as shown in figure 1 or an
open end wrench.
2. Assemble the lower handle to the handle brackets
as shown in figure 2.
3. Secure the'handle with cotter hairpins on both
sides. See figure 2.
4. Place the handle panel over the lower handle and
fasten with the handle panel screw using a 5/16"
wrench. See figure 3.
5. Place the upper handle over the lower handle and
line up the holes as shown in figure 4.
6. Insert the curved head bolt from the inside and
tighten the knob by hand. See figure 4.
7. Place the throttle control in the handle panel and
assemble it with the two throttle screws using a
screwdriver. See figure 5.
8. Use the cable clip to fasten the throttle control wire
to the lower handle.
9. Check ALL nuts and bolts for correct tightness.
COTTE« HAIRPINS
\
||U
BOLTS
^ HANDLE PANEL
SCREW
V « f'
THROTUE I
SCREWS CAIilC CUT
FIGURE 2. LOWER HANDLE ASSEMBLY
FIGURE 3. HANDLE PANEL ASSEMBLY
FIGURE 4. UPPER HANDLE ASSEMBLY
5.16" WRENCH
FIGURE 1. LOOSE HARDWARE AND TOOLS
FIGURE 5. THROTTLE CONTROL ASSEMBLY
NOTE
It may be necessary to spread the ends
of the lower handle outward slightly
to assure a snug fit against the bracket
mounting area.