Aiwa CT-X409 - Manual (Page 7)

RADIO OPERATION
4
BAND TAPE CD/MD IN
Press PWR to turn the unit on.
The radio frequency appears.
Press BAND to select the band from
among FM1, FM2, FM3 and AM.
The band indicators appear cyclically in order.
(FM1, FM2 and FM3 share the same
frequency range.)
Band
indicator Frequency
indication
----- | . n U
lUU.
Press (more than 2 seconds) either
TUNE T or TUNE Ato tune in the desired
station.
The unit starts scanning and tunes in a station
automatically (seek tuning).
Press TUNE T to decrease and TUNE A to
increase the frequency.
Press the button again to cancel seek tuning.
Repeat the procedure until the desired station
is tuned in.
Note
If you press (less than 0.5 second at a time)
either TUNE T or TUNE A, the frequency
decreases or increases step by step.
Adjust the volume with +/—.
To turn the unit off
Press PWR.
Note
The unit turns on in the last selected mode when
you turned off the unit with the exceptions of
pressing the following buttons.
• Pressing TAPE turns on the unit in Tape Play
mode.
• Pressing BAND turns on the unit in Radio mode.
• Pressing CD/MD IN turns on the unit in CD/MD
IN mode.
Switching modes
When the unit is in Radio mode, inserting a
cassette switches the unit to Tape Play mode
automatically.
LO (local/DX) button
You can use Local mode when you wish to tune
in only strong stations during seek tuning. In
Radio mode, press LO to select Local mode. The
“LO” indicator lights up.
• Press LO to deactivate Local mode and switch
to DX (distance) mode.
•The “ST” (stereo) indicator lights up when the
tuned-in station is broadcasting in stereo and
the reception is good.
ENGUSH 6