Aiwa CT-X409 - Manual (Page 12)

TAPE PLAYBACK
SOUND ADJUSTMENTS
Before turning the ignition off
Be sure to eject any cassette from the unit before
turning the ignition off. Otherwise, the unit may be
damaged when you detach the front panel.
Switching modes
When the unit is in Radio mode, inserting a
cassette switches the unit to Tape Play mode
automatically.
To prevent tape problems
Before inserting a cassette into the unit, make
sure that there is no slack in the tape. If necessary,
take up the slack by inserting a pencil into the
spindle hole and winding.
90-minute or longer tapes are extremely thin and
easily deformed or damaged. They are no
recommended.
2 1
MUTE
wish to adjust from: VOL (volume), BAS
(bass), TRE (treble), BAL (balance) and
FAD (fader).
The following indications appear in cyclic
order.
j~*UDL-*SR5~*T PE~*SRL~*’FR]}~f
If you do not proceed with step 2 within 5
seconds, the selected mode is canceled, and
the indication returns to the current source
mode.
Press +/— to adjust the level.
Press and hold either button to change the
level rapidly.
Adjust each mode referring to the audio
control indicators in the display window (see
page 3).
—
+
lini
u u ¡_
Decreases the
volume level
Increases the
volume level
II Q C
Jj n _<
Decreases the
bass level Increases the
bass level
T oc
< M ¡_
Decreases the
treble level
Increases the
treble level
II pi
MriL
Decreases the
level of the right
speaker(s)
Decreases the
level of the left
speaker(s)
CO
r n M
Decreases the
level of the front
speakers
Decreases the
level of the rear
speakers
Without selecting any mode with SEL, only
the volume level can be adjusted by pressing
+ / - .
MUTE button
Press this button to temporarily lowerthe volume.
Press it again to restore the previous volume.
11
FNGUSH