Beko BT-100 - Manual (Page 9)

-time." While you arespeaking, you can
not receive a transmission. The PMR is
an open-license band. Always identify
yourself when transmitting on the same
channel.
a number on the LCD Screen. At the
highest level, the units wll pickup
softer noise (including background
noise); at the lowest level, it will pick
up only quite loud noise.
Transmittina (sendina a speech)
■
a. Press and hold the PTT g
(push to talk) button to transmit
your voice. “TXwill be displayed
on the LCD Screen.
A
■
b. Hold the unit in a vertical
I
9
position with the MIC
(Microphone) 5 cm away from the
mouth. While holding the PTT button,
speak Into the MIC (microphone) in a
normal tone of voice,
c. Release the PTT button when you
have finished transmitting.
a. Press the MENU button 4
times, “VOX” will be displayed
and "OP flashes on the LCD
Screen.
b. Press the UP button to set
the VOX sensitivity level (the
maximum level is“3 ”.) To
deactivate the VOX tunction, press the
DOWN button until "OF" appears on
the LCD Screen, c. Press the PTT button
to confirm your setting. “VOX” will
steadily appear on the LOD Screen as
along as the VOX feature is activated.
Monitor
You can use the Monitor feature to
check for weak signals on the current
channel.
a.Press and hold the MENU
* and DOWN buttons at the
same time. “RX” will be
^ displayed on the LCD Screen.
i Your PMR will pick up
_____ signals on the current channel,
including background noise,
b. Press the PTT button to stop the
channel monitoring.
Setting the VOX (Voice Activated)
Sensitivity
In VOX mode, the PMR will transmit
a signal only when it is activated by
your voice or other sounds around
you. The unit will transmit further for 2
seconds even It you stop talking. The
level of VOX sensitivity is shown by
VOX operation is not recommended if
the PMR will be used in a noisy or windy
environment.
Vibrator and Caii aiert
Your FX-117 can alert you to incoming
signal by emitting an audible call tone
and vibration signal.
Call-Ring tone
You can send a Call-ring tone to other
PMR users to give an alert that you want
to communicate with them.
Press the CALL button Yu will
hear a ring tone for about two
seconds; ‘TXappears on the
LCD Screen. Any other units
within the transmitting range
_____ and turned to the same
channel and sub-channel (if applicable)
will hear the Call-ring tone.