BUSH DFTA9DVD - Manual (Page 11)

Troubleshooting-DVD
I f you have any questtona, please consult ttie troubleshooting guide below.
I
NO PICTURE OR SOUN d I
• Ensure the powerbutton Ison.
• Ensure the power outlet is operational.
• Ensure the power cord Is not damaged.
• Ensure the power plug Is connected firmly to the outlet.
I
*BAD DISC' DISPLAYED~|
d Ensure the disc Is not warped, damaged or deformed.
• Ensure the disc Is not badly stained or damaged,
d Ensure the disc format Is compatible with the player.
[ picture but no sound ]
I
REMOTE NOT WORKIN^
d Ensure the Audio Jacks are securely connected.
• Ensure the Audio Connector Is not damaged,
d Ensure the volume Is turned up.
• Ensure you have set the playersAudIo Settings correctly,
e EnsureyouhaveenteredthecorrectAVInputforyourTV. • Remove any obstacles between the Remote and the
• Ensure the audio Is not set to mute. IRsensor.
d Make sure the Main unit's POWER button Is on
d Ensure the Remote batteries are working,
d Point the Remote Control directly at the players IR
sensor.
[SOUND BUT NO PICTURE
• Ensure the Video Jacks are securely connected,
d Ensure you have entered the correct AV Input for your TV.
d Ensure the Video Connector Is not damaged,
d Ensure you have set the player's Video Settings correctly.
lUNfT NOT WORKING I
• Turnoff the power and then turn It on again.
[ POOR PICTURE OR SOUNP| |'NO DISC DISPLAYED |
d Ensure you have set the playersAudIo Settings correctly, d Ensure you have put the disc on the tray.
d Ensure the disc Is not scratched or stained,
d Ensure the AV Connector or the output terminal Is not
damaged.
d Ensure the disc Is not upside down,
d Ensure the disc Is not distorted, stained or scratched.
Troubleshooting-DVB-T
If you experience problems with this receiver or Its Installation, please read carefully
the relevant sections of this User Manual and this Troubleshooting section.
Problem Possible cause What to do
Standby light not lit Mains lead unplugged Check mains lead
Mains fuse blown Check fuse
No signal found Aerial is disconnected
Aerial is damaged/misaligned Check aerial lead
Check aerial
Out of digital signal area Check with retailer
No picture or sound
Program not broadcasting
Press the DTV/VCR
button
Re-tune to another
channel
Mosaic blocks in picture
or picture freezes
Aerial may not be compatible Check aerial
Scrambled channel
message Channel is scrambled Select an alternative
channel
Locked out of
channels Forgotten channel
lock code
Re-install channels to
cancel channel lock
No response to
Remote Control
Receiver off Plug in and turn on
receiver
Handset not aimed correctly Aim handset at front
panel
Front oanel obstructed Check for obstructions
Remote control batteries are
inserted incorrectly Check batteries
direction
Handset batteries exhausted Replace Remote Control
batteries
After moving the receiver
to another room, you
can’t receive the digital
reception
The aerial feed may come
through a distribution system
which may reduce the digital
signal now received by the
receiver
Tty a direct feed
from the antenna