Line 6 M13 - Manual (Page 11)

Setup Details
2•1
s
etup
d
etAils
Before you begin using your M13, it’s always a good idea to get in tune.
Tuner
To enter Tuner mode, press and hold the Tap switch for a few seconds. LCD 3 will display
the Tuner. LCD 4 will display the note you’re tuning.
If you’d like to tune to a reference other than standard 440, turn Knob 3 to select from
425 to 455. To toggle between Mute Audio (your guitar will be silent) and Bypass Audio
(you’ll hear your guitar dry with no FX), turn Knob 5.
[ ]
50 50
440HZ MUTE
AUDIO REF
b #
BYPASS
AUDIO
[ ]
50 50
440HZ MUTE
AUDIO REF
b #
BYPASS
AUDIO
D
Tuning is straightforward: when the graphic diamond is to the left of center, your note is
flat; when it’s to the right, you’re sharp. When the diamond is precisely in the center, two
triangles will appear above and below it, indicating your string is in tune.
To exit Tuner mode, press Tap again, or any other footswitch.
Setup Mode
To enter Setup mode, press and hold the Looper Controls switch for a few seconds.
The M13’s four LCDs will display your settings, including Expression Pedals in LCD 1,
Tempo, Looper Levels & EQ in LCD 2, Preferences, Scenes & FX Loop in LCD 3, and
MIDI, Gate & Displays in LCD 4.
Depending on the way you like to work, most of your Global settings can be left as is after
you’ve set them initially. They’ll be recalled each time you power-up. Some settings are
saved with individual presets. In the following pages we’ll describe them all in detail.