Hunter XC - Manual (Page 16)

13
ENG
Easy Retrieve ™ Program Memory
The XC is capable of saving the preferred watering program
into memory for retrieval at a later time. This feature allows
for a quick way of resetting the controller to the original
programmed watering schedule.
To save the program into the memory
1. With the dial in the run position, press and hold the
and buttons for 5 seconds. The display will scroll three
segments from left to right across the display indicating
the program is being saved into memory.
2. Release the and buttons.
To retrieve a program that was previously saved into
memory.
1. With the dial in the run position, press and hold the
and buttons for 5 seconds. The display will scroll three
segments from right to left across the display indicating
the program is being saved into memory.
2. Release the and buttons.
Programmable Delay Between Stations
This feature allows the user to insert a delay between stations
between when one station turns off and the next one turns on.
1. Start with the dial in the run position.
2. Press and hold the button down while turning the dial
to the run TImes position.
3. Release the button. At this point the display will show
a delay time for all stations in seconds, which will be
flashing.
4. Press the or buttons to increase or decrease the
delay time between 20 seconds and 4 hours.
5. Return the dial to the run position.
Clearing the Controller's Memory/Resetting the
Controller
If you feel you have misprogrammed the controller, there is a
process that will reset the memory to the factory defaults and
erase all programs and data that have been entered into the
controller.
1. Press and hold down the button.
2. Press and release the reset button in the lower
wiring compartment.
3. Wait 2 seconds and release the button. The display
should now show 12:00 AM . All the memory has been
cleared and the controller may now be reprogrammed.
adVanCed feaTures