Hunter XC - Manual (Page 13)

ENG
10
Automatic Watering
After programming the XC, set the dial to the
run position to enable automatic execution of all
selected watering programs and start times.
System Off
Valves currently watering will be shut off after
the dial is turned to the sysTem off position
for two seconds. All active programs are dis-
continued and watering is stopped. To return
the controller to normal automatic operation,
simply return the dial to the run position.
Programmable Rain Off
This feature permits the user to stop all
programmed waterings for a designated
period from 1 to 7 days. At the end of the
programmed rain off period, the controller
will resume normal automatic operation.
1. Turn the dial to the sysTem off
position. Wait for off to be displayed.
2. Press the button as many times as needed
to set the number of days off (up to 7 days).
3. Turn the dial back to the run position at which
off, a number, the and icons will be
displayed.
The days off remaining will decrease at
midnight each day. When it goes to zero,
the display will show normal time of day
and normal irrigation will resume at the
next scheduled start time.
Selecting Interval Watering
With this option you can select interval
watering from 1 to 31 days.
1. With the cursor on eVen, press the
button once and
the icon will appear and a 1 flashing in the display.
Interval watering schedule appears on the display.
2. Press the or button to select the number of days
between watering days (from 1 to 31 days). This is called the
interval.
The controller will water the selected program at the next start
time and will then water at the interval programmed.
Setting Event Day(s) Off
The XC allows you to program a No Water Day(s). This feature is
useful to inhibit watering on specific day(s). For example, if you
always mow the lawn on Saturdays, you would designate Saturday
as a no Water day so that you are not mowing wet grass.
1. Turn the dial to the WaTer days position.
2. Enter an interval watering schedule as described on page 10.
3. Press the button to scroll to the no WaTer days at the
bottom of the display. mo will be flashing.
4. Use the button until the cursor is at the day of the week
you wish to set as a No Water Day.
5. Press the button to set this day as a no water day. The
will illuminate over this day.
6. Repeat steps 4 and 5 until all desired event day(s) are off.
NOTE: You also have the option in the interval
watering schedule to program Odd or Even days
off.
programmIng THe ConTroller
SYSTEM OFF
RUN
RUN
SYSTEM OFF