Hunter SRC - Manual (Page 22)

18 19
PROGRAMMING THE CONTROLLER (Continued)..............................................................
6. Hours will be flashing.
Press the or button
to change the hour shown
on the display. Press the
to proceed to setting the
minutes.
7. Minutes will be flashing.
Use the or button to
change the minutes shown on
the display. The date, day and
time have now been set and
the dial may be returned to the
RUN position.
Setting Watering Start Times
1. Turn the dial to the SET
WATERING START TIMES
position.
2. The factory preset is set on
program A. If necessary, you
can select program B or C by
pressing the button.
3. Use the or button to
change the start time.
(The start times advance in
15 minute increments.)
Hold either button down for 1
second to change times rapidly.
4. Press the button to select the
next start time, or press for
the next program.
NOTE: One start time will activate all stations
sequentially in that program. This eliminates the
need to enter each station’s start time. Multiple
start times in a program can be used for separate
morning, afternoon, or evening watering cycles.
Eliminating a Program Start Time
With the dial set to the SET WATERING START TIMES position, push the
or button until you reach 12:00
AM
(Midnight). From here push the
button once to reach the OFF position.
NOTE: If a program has all four-start times turned
off, then that program is off. (All other program
details are retained). Because there are no start
times, there will be no watering with that program.
This is a convenient way to stop watering on one
program only without turning the dial to the OFF
position.
PROGRAM
START
TIMES
STATION RUN TIME
YEAR
MONTH
DAY
RUNNING
AM
PM
24 HR.
SUN MON TUES WED THUR FRI SAT EVEN/ODD
PROGRAM
START
TIMES
STATION RUN TIME
YEAR
MONTH
DAY
RUNNING
AM
PM
24 HR.
SUN MON TUES WED THUR FRI SAT EVEN/ODD
A
B
C
1
2
3
4
PROGRAM
START
TIMES
STATION RUN TIME
YEAR
MONTH
DAY
RUNNING
AM
PM
24 HR.
SUN MON TUES WED THUR FRI SAT EVEN/ODD
SET WATERING
START TIMES