MTD 645C thru 651C - Manual (Page 4)

ASSEMEILY INSTRUCTIONS
AHACHING THE UPPER
GUIDE ASSEMBLY
Flat
Was her
5/16' I.D.
Hex Lc ck
Nut5/1(i-18
Thread
Hex Bolt
5/16-18 X 8-3/8" Long
IMPORTANT: This unit is shipped WiTHOUT
GASOLiNE or OiL. After assembly, see separate
engine manual for proper fuel and engine oii rec­
ommendations.
NOTE: To determine right and left hand sides of your
shredder, stand behind the unit with the engine the
farthest away from you. See figure 6.
Your shredder has been completely assembled at the
factory, except for the hopper assembly (hopper hood
and upper guide extension have been sub-assem­
bled), upper guide assembly, chute deflector and the
catcher bag. The hardware pack and a pair of safety
glasses are also included in the carton.
The hardware pack contains the parts shown in figure
1 (shown full size).
TO REMOVE SHREDDER FROM CARTON
1. Remove staples, break glue on top flaps, or cut
tape at carton end and peel along top flap to
open carton.
2. Remove loose parts if included with unit (i.e.,
owner’s manual, etc.).
3. Cut along dotted lines and iay carton down flat.
4. Remove packing material.
5. Roll or slide unit out of carton. Check carton
thoroughly for loose parts.
TOOLS REQUIRED FOR ASSEMBLY
(1) Phillips Screwdriver
(2) 1/2" Wrenches (one must be a socket wrench)
(2) 7/16" Wrenches or Adjustable Wrenches
B
AHACHING THE HOPPIER ASSEMBLY
Truss Machine
Screws 1/4-20 x 1/2"-
Long
Hex Lock Nuts
1/4-20 Thread
FIGURE 1.