MTD 214-031-000 - Manual (Page 9)

DEPTH BAR ADJUSTMENT
The working depth of the tiller is determined by
the position of the depth bar. Remove the clevis
pin and internal cotter pin to raise or lower depth
bar. See figure 14.
Depth Bar
S ix Hole
Adjustment.
Clevis Pin a
Internal Cl
FIGURE 14.
TILLING WIDTH
There are three tilling widths available.
Remove the spark plug wire from spark plug and
ground before making any adjustments to tine
width.
1. Standard tilling width is 18 inches. See figure
15.
3/8" Wrench
Self-Tapping
Screws
FIGURE 16.
FIGURE 15.
2. A narrower width (14 inches) can be obtained
by removing both outer tines. Use a 3/8"
wrench to remove the two self-tapping screws
on the outside of the tines. See figure 16.
Replace the first tine removed as shown in
figure 17.
FIGURE 17.
3. The minimum tiller width that can be obtained
is 10 inches. Remove the outer tines by remov­
ing the two self-tapping screws on the outside
of the tines. See figure 18.
Self-Tapping
Screws
Self-
Tapping
Screws
FIGURE 18.