MTD 214-031-000 - Manual (Page 5)

Carriage
Boit (A)
4. Place the handle panel in position on the up­
per handies. Secure in position with four car­
riage bolts (A), lock washers (B) and hex nuts
— (C). See figure 4.
Handle
Panel
\
Cable Support
Lock Bracket
Washer (B)
Hex Nut (C)
NOTE
Carriage bolt on the upper left hand
side of handle panel also secures
the cable support bracket.
5. Tighten securely all nuts and bolts used in
handle assembly.
FIGURE 4.
6. Assemble the throttle control to the handle
panel as follows.
A. Hold the throttle control assembly
beneath the handle panel. Turn the control
sideways and insert the lever up through
the wide portion of the slot on the handle
■ panel. See figure 5A.
B. After the end of the iever is through the
slot, turn and then tip the control forward
■as shown in figure 5B to slide it through
the slot.
NOTE
The lever must be all the way to the
back of the control housing as
shown in figure 5B.
C. Push the control back into the slot in the
handle panel and press in place. Be certain
the control is locked securely into the slot.
-See figure 5C.
FIGURE 5.