Poulan 168737 - Manual (Page 13)

bier ® Allow one minute for transmission to warm up. This
can be done during the engine warm up period.
The attachments can also be used during the engine
warm-up period after the tran.smission has been waimea
C i ,
np pnrf fpf
- r fuel
uld Í
^age. To avoid engine
be erriDtied before stor- up.
MOTHi If 3Í E hiyli sitituds (sbovs 30^ JO fG0[i C
■'ain
.S 9 £ 1 0 S f C ' 0 " 0 0 J0f li
" ~c i <„arcu. s.c " a
h ilJ6( fTilX
asor 1. See Storage Instruc-
3 3.nd AdH JSIITI
)n. Never use engine or
-'-A t ” r-nt
ssGiion Of lilis msnusí.
A
WAtJ
filler
ed oil or
IME
ue!
neg
5cr*c t ; ci ¿J z . .yfl
ir iftp's :rra'
~'C^ AO'B. spif’
see r-i
w i r - w ~ I i 2 ' = A M r ' - O ' m e
. I ! " 'M 'K^c AK Tc " t /e
'
s in the transmission en-
fuel from the -driK
b e sure
aaaed oc
see! com
)n
’ tt< tr - 1 !, mc'cji t - i.iCi aepress clutch/Diake
ptjai C..-.U set park..ng'c,c;ke.
• Place motion control lever in neutral (N) position.
® yove attachment dutch to “DISENGAGED” position.
•• Move throttle control to choke position.
NOTE: Before starting, read the warm and cold starting
procedures below.
» Insert key into ignition and turn key ctockv/ise to “START"
position and release key as soon as engine starts. Do
not run starter coniinuously for .more than fifteen sec­
onds per minute. If the engine does not start after
several attempts, move throttle control to fast position,
wait a few minutes and try again, if engine still does not
start, move the throttle control back to the choke
position and retry.
WARM WEATHER STARTING (50° F and above)
• When engine starts, move the throttle control to the fast
position.
® The attachments and ground drive can now be used. If
the engine does not accept the load, restart the engine
and allow it to warm up for one minute using the choke
as described above.
COLD WEATHER STARTING ( 50° F and below)
• When engine starts, allow engine to run with the throttle
controi in the choke position until the engine runs
roughly, then move throttle control to fast position. This
may require an engine warm-up period from several
seconds !o several minutes, depending on the tem­
perature.
AUTOMATIC TRANSMISSION WARM UP
® Before driving the unit in cold weather, the transmis­
sion should be warmed up as follows;
® Be sure the tractor is on level ground.
® Place the motion control lever in neutral.
Release the parking brake and lei the ciutch/brake
slowly return to operating position.
PORGI T°0 MOI
¿r* f
Ti, r
nino.
1 0 ensure proper«
T b'lupo '(¡a To ' lission De pi.
tractor for the first time. This proc 6GUr€3 Will rGrnove a
1
, C,r - ‘>-r r --------- i •- WhlCr Ì ÍÜW have dov'
■ mr:*’ M m .I J ' " i "
i.uiPOF’^rt m ^ > .NSMiISSION REOUT
R E M O V A L FOR SERVICE OR
I N S T A L L A T S C SHOULD BE PURGED .AFTEF
= E - 'P-E E-F IV 1 E - / U TOR.
® F a c e , £,'< / q-. tov«i face V!/iih engine otfai
pc fc ' a* fr t
® Disengage transmission by pic icing freewhesi conti
in freewheelinq position (See
ííT‘f\ '
TRANSPORT”
I ! '
Sittinq in thi
» ■
,
3 n c
»dure thre^
ir i
.( '■•■'p- • n
ai (N) position, sic
NOTE: During this procedure there will be no movement of
drive wheels. The air is being removed from hydraulic drive
system.
® Move motion control leverio neutral (N) position. Shut­
off engine and set parking brake.
» Engage transmission by placing freewheel control in
driving position (See “TO TRANSPORT” in this section
of manual).
® Sitting in the tractor seat, start engine. After the engine
is running, move throttle control to half (1/2) speed.
With motion control lever in neutral (N) position, slowly
disengage ciutch/brake pedal.
® Slowly move motion control lever forward, after the
tractor moves approximately five (5) feet, slowly move
motion control lever to reverse position. After the
tractor moves approximately five (5) feet return the
motion control levertothe neutral (N) position. Repeat
this procedure with the motion control lever three (3)
times.
® Your tractor is now purged and now ready for normal
operation.
13