Maintenance and troubleshooting, Battery replacement, Handgrip pulse sensor troubleshooting – NordicTrack 831.23665.0 User Manual

Page 19: How to eliminate rubbing of the discs, How to adjust the belt

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the elliptical exerciser

regularly. Replace any worn parts immediately

To clean the elliptical exerciser, use a damp cloth and

a small amount of mild soap. Important: To avoid

damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.

BATTERY REPLACEMENT

If the console displays become dim, the batteries

should be replaced; most console problems are the

result of low batteries. See assembly step 9 on page

8 for replacement instructions.

HANDGRIP PULSE SENSOR TROUBLESHOOTING

If the handgrip pulse sensor does not function proper

ly see step 5 on page 15.

HOW TO ELIMINATE RUBBING OF THE DISCS

If the Discs (12) rub against the Side Shields (14, 15)

during use, make sure that the Center Foot (40) is

installed in the Frame (1). If the Center Foot is
installed, loosen the two indicated Bolt Sets (88) and

the two M4 X 16mm Screws (78) in each side of the
elliptical exerciser.

HOW TO ADJUST THE BELT

If the pedals slip while you are pedaling, even while

the resistance is adjusted to the highest setting, the
belt may need to be adjusted. To adjust the belt, first
see assembly step 12 on page 10 and remove the left
pedal arm and the left link arm.

Then, carefully
pry off the left

Disc Cover (13)
using a flat

screwdriver.

Next, remove the

four screws (not
shown) from the
center of the left

Disc (12). Gently
rotate the Disc
Cover and the
Disc away from the elliptical exerciser.

Loosen, but do
not remove, the

three indicated
screws (A), insert
the shaft of a
screwdriver
downward
between the

Idler (47) and the
Idler Pulley (48).

Pull the top of the

screwdriver
toward the front
of the elliptical exerciser until the Belt (74) is tight.
Then, tighten the three screws.

Reattach the left disc with the four screws and then
reattach the left disc cover. Next, see assembly step
12 on page 10 and reattach the left pedal arm and the
left link arm.

Adjust the position of the Side Shields (14, 15) until
the Discs (12) no longer rub against them, and then
tighten the Bolt Sets (88) and the M4 x 16mm Screws

(78).