NordicTrack 831.23665.0 - Manual (Page 14)

HOW TO USE THE MANUAL MODE
Note: If there is a sheet of clear plastic on the face of
the console, remove the plastic.
1 Press any button on the console or begin
pedaling to turn on the console.
When you turn on the console, the display and
the program target pacer will light. A tone will
then sound and the console will be ready for use.
m Select the manual mode.
When you turn on the console, the manual mode
will be selected. If you have selected a program,
reselect the manual mode by pressing any of the
Programs buttons repeatedly until a track appears
in the left side of the display.
□
I I
Time
nn ri
iJ'IJ u
RPM
D
I Begin pedaling and change the resistance of
the pedals as desired.
As you pedal,
change the resis­
tance of the pedals
by pressing the
OneTouch Resis­
tance buttons. There
are ten resistance levels. Note: After you press
the buttons. It will take a moment for the pedals
to reach the selected resistance level.
The upper right sec­
tion of the display can
show the elapsed
time, the distance
(total revolutions) you
have pedaled, the
approximate number of calories you have burned,
and the approximate number of grams of carbs
you have burned. The display will change modes
every few seconds.
The lower right sec­
tion of the display can
show your pedaling
pace (in revolutions
per minute) and the
resistance level of the
pedals. The display will change modes every few
seconds. The display will also show your heart
rate when you use the handgrip pulse sensor (see
step 5 on page 15).
The left section of the
display will show a
track representing 1/4
mile. As you exercise,
indicators will appear
in succession around
the track until the
entire track appears.
The track will then disappear and the indicators
will again begin to appear in succession
To change the display mode, press the Display
button repeatedly until the desired exercise infor­
mation appears in the upper or lower right display.
After several seconds, the display will change
modes automatically as before.
To view the total distance pedaled since the ellipti­
cal exerciser was purchased, press the Odometer
button. The information will appear In the display
for a few seconds. To view the trip distance, press
the Odometer button a second time. To reset the
trip distance, hold down the Odometer button for a
few seconds. Note: The number on the right side
of the display multiplied by the number on the left
side equals the total distance or the trip distance.
Follow your progress with the displays.
1 ^