beautypg.com

Engine, Spark plug, Air filter – MTD 110-017R000 User Manual

Page 10: Cleaning, Service and adjustments, To adjust handle height, To adjust cuning height, Carburetor, Engine speed, Rear trail shield

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

MAINTENANCE

Careshouldbetakentokeepthebladebalanced.

An

unbalanced blade will cause excessive vib ation

when running and eventual damage to mower and

engine.

To check blade balance, drive a nail into a beam or

wall. Leave about one inch of the straight nail

exposed. Place center hole of blade over the head
of the nail. If blade is balanced, it should rema n in a
horizontal position. If either end of the blade moves

downward, blade is not balanced. Sharpen the
heavy end until the blade is balanced.

ENGINE

SPARK PLUG

Change your spark plug each year to make your engine
start easier and run better. Set spark plug gap a .025
inch.

AIR FILTER

Your engine will not run properly and may be damaj led by
using a dirty air filter.

Replace the air filter every year, more often if you n low in

very dusty, dirty conditions. Do not wash air filter, -liters

are available at your nearest Tecumseh Dealer.

CLEANING

A

CAUTION: DISCONNECT SPARK PLUG WIRE
FROM SPARK PLUG AND PLACE WIRE WH ERE IT
CANNOT COME IN CONTACT WITH THE SPARK
PLUG.

Clean your mower and engine often to keep build-up

of trash from accumulating around engine. A
clogged engine runs hotter and shortens engine life.

Turn mower on its side with carburetor up.

Clean the underside of your mower by scraping to

remove build-up of grass and trash.

NOTE: We recommend that you clean the underside of

your mower after each use. We DO NOT recommend

using a garden hose to clean mower unlessthe electrical
system, muffler, air filter and carburetor are covered to
keep water out. Water in engine can result in shortening
engine life.

SERVICE AND ADJUSTMENTS

TO ADJUST HANDLE HEIGHT

See "ATTACH LOWER HANDLE" in assembly sec (ion of

manual.

TO ADJUST CUniNG HEIGHT

See "ADJUST CUTTING HEIGHT' in operation section
of manual.

CARBURETOR

Your carburetor has a non-adjustable fixed main jet for

mixture control. If your engine does not operate properly
due to suspected carburetor problems, take your mower

to a authorized Service Center for repair and adjus tment .

ENGINE SPEED

Your engine speed has been factory set. Do not attempt
to increase engine speed or it may result in personal

injury. If you believe that the engine is running too fast or

too slow, take your mower to an authorized Service

Center for repair and adjustment.

REAR TRAIL SHIELD

The reartrail shield, attached between the rear wheels of
your mower, is provided to minimize the possibility that
objects will be thrown out the rear of the mower into the
operator mowing position.

If the shield becomes damaged, it should be replaced.

10