Contents of hardware pack, Loose parts in carton, Unpacking – MTD 692 thru 699 User Manual
Page 3: To remove unit from carton, Tools required for assembly, Loose parts in carton unpacking
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6. Never tamper with safety devices. Check their proper opera
tion reguiarly.
7. Do not aiter or tamper with the engine’s governor setting. The
governor controls the maximum safe operating speed of the
engine. Over-speeding the engine is dangerous and will cause
damage to the engine and to other moving parts of the machine.
OWNER’S
MANUAL
SAFETY LABEL
CONTENTS OF
HARDWARE PACK
▲
WARNING
—
YOUR RESPONSIBILITY
Restrict the use of this power machine to persons who read,
understand and follow the warnings and instructions in this
manual and on the machine.
LOOSE PARTS IN CARTON
UNPACKING
TO REMOVE UNIT FROM CARTON
1.
Remove staples, break glue on top flaps, or cut
tape at carton end and peel along top flap to
open carton.
2.
Remove loose parts if included with unit (i.e.,
owner’s manual, etc.)
3. Cut along dotted lines and lay carton down flat.
4. Remove packing material.
5.
Roll or slide unit out of carton. Check carton
thoroughly for loose parts.
6.
Lay out the contents of hardware pack according
to the illustration at left.
TOOLS REQUIRED FOR ASSEMBLY
(1) 1/2" Open End or Box Wrench