Note – MTD 113-011A User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
End of
Brake
Cable
NOTE
It may be necessary to push the end
of the brake cable using a screw-
■ driver as shown in figure 7 to allow
enough slack for the cable to be as
sembled to the blade control handle.
FIGURE 7.
Throttle
„ *tioi^№c.ever
On Engine
Screw
FIGURE 8—Units with remote throttle controls
only.
NOTE
Steps 9 through 12 are for units with
remote throttle controls only.
9.
Place the throttle control lever on the handle
in “Fast” position.
10.
Push the throttle control lever on the engine
to the full open position (as far toward the out
side of the unit as it will go) as shown in figure
-------------
8
.
11.
Hook the “Z” end of the throttle control cable
into
the
hole
in
the
control
lever
on
the
engine.
12.
Loosen
(do
not
remove)
the
screw
on
the
cable clamp shown in figure 8. Slip the control
casing under the clamp. With the throttle lever
on the engine still in the full open position,
tighten
the
screw
to
secure
the throttle con
trol cable.
P
13.
Secure
cables
to
upper
and
lower
handles
-------with cable ties (D). See figure 9.
FIGURE 9.