Note, Assembly instructions, Ik-m – MTD 113-011A User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
NOTE
Reference to right or left hand side
of the mower is observed from the
operating position.
ASSEMBLY INSTRUCTIONS
►NOTE
J V- «
®
Ì
:|
1
t
ii
A
jr-. r, G^- ^
jr
,.00
B
:i-
«
4
» »
I
k-M
FIGURE 1.
Upper
FIGURE 2.
Rope
Guide
This unit is shipped WITHOUT GAS
OLINE
or
OIL.
After
assembly,
see
separate
engine
manual
for
proper
fuel
and
engine
oil
recommenda
tions.
■Contents of hardware pack: (See figure 1)
A (4) Shoulder Bolts 3/8-16 Thread
B (8) Belleville Washers 3/8" I.D.
C (4) Hex Nuts 3/8-16 Thread
D (2) Cable Ties
E (2) Shoulder Bolts 5/16-18 Thread
F (2) Belleville Washers 5/16" I.D.
G (2) Hex Lock Nuts 5/16-18 Thread
H (1) Rope Guide Bolt
I (1) Curved Head Carriage Bolt
J (2) Lock Washers 5/16" I.D.
K (2) Hex Nuts 5/16-18 Thread
1.
Remove lawn mower and loose parts from car
ton. Make certain all parts and literature have
been removed from the carton before the car
ton is discarded.
2.
Extend the throttle control cable (optional) (at
tached
to
the
upper
handle)
and
the
brake
cable
(attached
to
the
engine)
and
place
on
the floor. Be careful not to bend or kink con
trol cables.
3.
Line up the upper slotted hole in the lower
handle with the mounting hole on deck. Place
shoulder
bolt
(E)
through
lower
handle
and
deck.
Place
belleville
washer
(F)
on
the
shoulder
bolt,
with
the
cupped
side
of
the
washer against the deck. Secure with hex lock
------- nut (G)- See figure 2.
NOTE
It
may
be
necessary
to
bend
the
ends
of
the
lower
handle
inward
slightly
to
obtain
a
tight
fit
against
the deck.
4.
Place the upper handle in position over the
lower handle. The control housing must be on
the right hand side of the handle. Secure the
right hand side of upper handle using the rope
guide bolt (H), lock washer (J) and hex nut (K)
—as shown in figure 3.
FIGURE 3.
NOTE
Left
handed
operators
may
assem
ble the rope guide bolt to the left
hand side of the handle for easier
starting.
5.
Secure
the
other
side
of
the
handle
with
curved head bolt (I), lock washer (J) and hex
nut (K).