Note, Blade, Slot – MTD 113-011A User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Four
Cutting
Heights
Belleville Washer
Your mower has four height settings. Use the
same mounting hole for all four wheels when
-assembling. See figure 4.
A.
Place shoulder bolt (A) through wheel. See
figure 4.
B.
Place cupped side of belleville washer (B)
towards
the
deck
(away
from
wheel).
See
figure 4.
C.
Place
shoulder
bolt
through
desired
mounting
hole
on
deck.
Secure
with
belleville
washer
(B)
(cupped
side
goes
against the deck) and hex nut (C).
FIGURE 4.
Brake
Cable
Slot
Upper Hole
on Bottom of
Housing
7.
Place the end of the brake cable into the up
per hole on the bottom of the control housing,
— and through the slot as shown in figure 5. Be
careful not to bend or kink the cable.
NOTE
The control cables should be as
sembled under the lower handle.
FIGURE 5.
Blade
Control
Handle
"Z" End of
Brake Cable
Snap
the
end
of
the
cable
into
the
control
housing. Hook the “Z” end of the brake cable
-into blade control handle. See figure 6.
FIGURE 6.