Cotter pin, Throttle – MTD 215-355AB2 User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HANDLE ASSEMBLY
CONTROL ROD
Assemble the handle to the bracket w^ith four cap
screws, washers and hex nuts. See figure 2.
Hex Nuts and Lockwashers
Hex Cap Sere
FIGURE 2. HANDLE ASSEMBLY
CLUTCH CONTROL
Place the clutch control lever through the handle pan
el. Attach it to the bracket with a screw and hex nut.
Two metal washers and a rubber washer are positioned
betwen the bracket and clutch control as shown in
figure 3.
Place the clutch control lever in neutral as shown in
figure 4. Screw the ferrule onto the control rod so that
approximately V
a
inch of threads are showing below
the ferrule. Assemble the ferrule to the pivot idler
bracket and secure with a cotter pin.
Adjust the ferrule location on the control rod so both
the forward and reverse belts are slack with the clutch
control lever in the NEUTRAL position. Secure with a
cotter pin.
Clutch Control Lever
Cotter Pin*
Control Rod
Cotter Pin
J
ff
FIGURE 4. CONTROL ROD
Cotter Pin
THROTTLE
Assemble throttle control as shown in figure 5.
FIGURE 3. CLUTCH CONTROL
FIGURE 5. THROHLE CONTROL