MTD TMO-33849A User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
24. With a piece of strong wire hook the end of
helper springs (Z) up into grille mount on lawn
tractor. See figure 22.
25. After springs are installed raise and lower the lift
handle on lawn tractor to be sure snow thrower
is properly hooked up.
26. Using a 1/2" wrench, tighten securely hex bolts
(V) which are threaded into the spring inserts.
Refer to step number 4.
FIGURE 22
27. Attach the pre-assembled chute crank and support
(AB) to the snow thrower housing. Secure the
support with two hex bolts (L), lock washers
(I) and hex nuts (Q). Secure the chute crank with
two hex bolts (M), lock washers (I) and hex nuts
(Q). See figure 23. Be sure teeth on chute crank
link up with holes in chute flange before
tightening bolts.
Remove the piece of plastic film from the gas cap.
Reinstall the battery and replace the spark plug
wire.
29. Check tire pressure. It may be necessary to put
more air into the front tires due to the weight of
the snow thrower.
FIGURE 23
11