MTD TMO-33849A - Manual (Page 10)

19. Slip the idler assembly belt over the engine pulley
as shown in figure 19.
NOTE
Be sure the belt runs between idler
pulley and guard as shown in figure 19.
20. Replace the engine pulley belt keeper and large
shoulder bolt. See figure 20.
21. Set the lawn tractor back down on all four wheels.
22. Roll the lawn tractor over the snow thrower and
attach the free end of the 85" belt to the pulley
on the idler assembly. Be sure to twist the belt so
that the top of belt coming off the idler goes
toward the left side of unit. See figure 8.
FIGURE 20
LINKAGE AFIM
FIGURE 21
10
NOTE
If belt is installed incorrectly spirals
will run in reverse. Twist belt in other
direction to correct. Refer to step 22.
23. Place the holes in the end of the linkage arms
in line with slot in the linkage brackets and
secure with lift handle shaft (AA) and hair pin
cotters (E). See figure 21. Lower the lift handle
on the lawn tractor to its lowest position.
NOTE
Linkage arms must be mounted on_the
outside of linkage brackets. Refer to
figure 21.