MTD 114-050-000 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
a.
Hook the “Z” end of the cable into notch
provided in the blade control handle. See
— figure 9.
b.
Squeeze blade control handle against up
per handle.
c.
Release the blade control handle, unhook
the cable from the notch and hook it into
the hole in the blade control handle.
7.
Place the throttle control lever on the handle
in “Fast” position.
8.
Push the throttle control lever on the engine
to the full open position (as far toward the out
side of the unit as it will go on Briggs and
Stratton engines and as far toward the rear of
the unit as it will go on Tecumseh engines) as
— shown in figure 10.
9.
10
.
FIGURE 10.
Hook the “Z” end of the throttle control cable
into
the
hole
in
the
control
lever
on
the
engine.
Remove the screw on the cable clamp shown
in figure 10. Slip the control casing under the
clamp. With the throttle lever on the engine
still
in
the
full
open
position,
replace
and
tighten the screw to secure the throttle con
trol cable.
11. Secure throttle control cable and brake cable
to upper and lower handles with cable ties (I).
------- See figure 11.
FIGURE 11.