Figure 6, Brake, J warning j – MTD 114-050-000 User Manual
Page 6: Blade
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Starter
Handle
Rope Guide
Bolt (E)
Lock Washer (G)
Hex Nut (H)
2.
Insert the rope guide bolt (E) through the right
hand side of upper and lower handle.
3.
The starter rope is wound around the starter
handle. Maintain the tension on the rope as
you unwind it.
4. Slip the starter rope into the rope guide bolt
■ as shown in figure 6. Secure the rope guide
bolt with lock washer (G) and hex nut (H). If
more
slack
is
needed
in
the
starter
rope,
disconnect and ground the spark plug wire.
Depress the blade control handle and pull ad
ditional rope out from the engine.
FIGURE 6.
Brake
Cable
Flange on
Plastic Fitting
Slot
Hole
on Bottom of
Housing
5. Route the brake cable under the lower handle.
Place the end of the brake cable into the up
per hole on the bottom of the control housing,
and through the slot in the side of the housing
— as shown in figure 7. The angle of the flange
on the plastic fitting must be positioned
downward as shown. Be careful not to bend or
kink the cable.
J WARNING J
Brake cable must be assembled as
shown for proper blade brake opera
tion.
Blade
Control
Handle
“Z” End
Brake Cable
6. Snap the plastic fitting on the end of the cable
into the throttie control housing. Hook the “Z”
end of the brake cable into the hole in the
— blade control handle. See figure 8. If addi
tional slack is needed in order to hook the
cable into the handle, proceed as follows.
FIGURE 8.