MTD 111-020-300 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Lower
Handle (K)------ ►
/
7. Place the upper slotted hole in lower handle
(K) over studs located in front of each rear
wheel. Secure with hairpin cotter (G) provided
— in hardware pack. See figure 4.
'^I^ld Stud
On Deck
FIGURE 4.
NOTE
It may be necessary to bend the
ends of the lower handle inward
slightly to assure a snug fit against
the deck mounting area.
NOTE
Figure 4 was photographed with the
rear wheel removed for clarity, it is
not necessary to remove wheel for
handle assembly.
-Upper Handle
Halves (J)
Hex Lock Nuts
4
^
(B)
Hex
Bolts (A)'
8. Assemble the upper handle halves (J) to lower
— handle using five hex bolts (A) and lock nuts
(B). Only tighten finger tight. See figure 5.
Hex Bolts (A)
Hex Lock
Nuts (B)
FIGURE 5.
Hex Lock
Nut (B)
9.
Place the tab on throttle control between the
upper handle halves at top hole. Secure with
hex bolt (C) and hex lock nut (B) provided in
------ hardware pack. See figure 6.
10. Tighten securely all six hex bolts and hex lock
nuts with 7/16" wrench.
FIGURE 6.