Assembly instructions, Figure 1, Note – MTD 111-020-300 User Manual
Page 4: Loose parts in carton: (see figure 2), A caution, Í^^ assembly instructions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
A
S-
í^^
ASSEMBLY INSTRUCTIONS
B
Jk I
V
V
G
FIGURE 1.
FIGURE 2.
Shoulder Bolt (E)
Belleville Washer (F)
Wheel (I)
FIGURE 3.
Four
Cutting
Heights
NOTE
This unit is shipped WITHOUT GAS
OLINE or OIL. After assembly, see
operating section of this manual for
proper fuel and engine oil recom
mendations.
Tools Required for Assembly:
(1) Adjustable Wrench
(1) 7/16" Open End or Box Wrench
(1) 3/4" Open End or Box Wrench
-Contents of Hardware Pack; (See Figure 1)
A (5) HexBolts 1/4-20 XIV
2" Long
B (6) Hex Lock Nuts V4-20 Thread
C (1) Hex Bolt
1/4 -20 x 13/4 " Long
D (2) Cable Ties
E (4) Shoulder Bolts (Axles)
F (4) Belleville Washers
G (2) Hairpin Cotters
H (2) Hand Grips (Not Shown)
Loose Parts in Carton: (See Figure 2)
I (4) Wheels
J (2) Upper Handles
K (1) Lower Handle
-1. Remove lawn mower and all parts from the
carton. Make certain that all loose parts and
literature have been removed before the car
ton is discarded.
2. Extend throttle control assembly which is at
tached to engine at the rear of the mower and
place on floor.
A CAUTION
Do not bend or kink control wires.
3. Your mower has four height settings. Use the
same hole for all four wheels when assem
bling. See figure 3.
4. Place shoulder bolt (E) through wheel (I). See
—figure 3.
5.
Place crown side of belleville washer (F)
towards the wheel (away from deck). See
figure 3.
6. Secure wheel to deck, using a 3/4" wrench.