Cal Spas LTR20051000 - Manual (Page 17)

Operating Your Spa
Operating Your Spa
1500 Electronic Control Operation
Figure 4. 1500 Electronic control panel
Temperature Adjustment
Range 80°F to 104°F
The 1500 electronic control panel (Figure 4) displays the actual water temperature in Fahrenheit.
To set the water temperature:
• Press the TEMPERATURE button. The temperature setting will flash.
• While the display is flashing, each time you press the TEMPERATURE button the set temperature will
increase one degree.
• Allow the display to revert back to the actual water temperature.
• Press the TEMPERATURE button again.
• While the display is flashing, each time you press the TEMPERATURE button the the set temperature will
decrease by one degree.
Standard Heating Mode
Your new spa is equipped with a heating feature that gives you complete control of the heating system. When
the spa is powered up, the heating system will automatically activate. Whenever the water temperature drops
more than one degree below the set temperature, the heating system will automatically activate and heat the spa
water to the set temperature.
Jet / Light Controls (One Pump Systems)
Press the JETS button:
• Once to activate the spa light
• Once to activate the pump at low speed
• Twice to activate the spa light and run the pump at high speed
2005 Spa Owner's Manual Page 13
8/1/2005