Operator’s positton (see fig. 1), Contents of hardware pack, Assembly – Poulan 172487 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
Your new tiller has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To
ensure safe and properoperation of yourtiller, all parts and hardware you assemble must be tightened securely. Usethe correct
tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard
wrench sizes are listed.
(1) Utility knife
(1) Tire pressure gauge
(1) Pair of pliers
{1)9/16" wrench
OPERATOR’S POSiTtON (See Fig. 1)
When right or left hand is mentioned in this manual, it means
when you are in the operating position (standing behind tiller
handies).
CONTENTS OF HARDWARE PACK
(2) Handle Locks
(1) Carriage Bolt
3/8-16 U N C x 1 Grades
(1) Center Locknut
3/8-16 UNC
(1) Flat Washer 13/32 x 1 x 11 Gauge
iMiiiil
n
(1) Pivot Bolt
3/8-16 UNC Grade 5
Extra Shear Pins & Clips