MTD 112-671A - Manual (Page 8)

The deck may be cleaned by tilting the mower for­
ward or on its side and scraping clean with a
suitable tool or by washing with a stream of water
from a garden hose.
t
warning {
Do not direct the stream of water at
a hot engine as damage to the
engine may result.
ENGINE
Refer to the separate engine manual for engine
maintenance instructions.
AIR CLEANER
Service air cleaner every 25 hours under normal
conditions. Clean every few hours under extreme­
ly dusty conditions. Poor engine performance and
flooding usually indicates that the air cleaner
should be serviced.
To service air cleaner, refer to the separate engine
manual packed with your mower.
SPARK PLUG
The spark plug should be cleaned and the gap
reset once a season. Spark plug replacement is
recommended at the start of each mowing
season; check engine manual for correct plug
type and gap specifications.
OFF-SEASON STORAGE
The following steps should be taken to prepare
lawn mower for storage.
1. Clean and lubricate mower thoroughly as
described in the lubrication instructions.
2. Refer to engine manual for correct engine
storage instructions.
3. Coat mower’s cutting blade with chassis
grease to prevent rusting.
4. Store mower in a dry, clean area.
HANDLE STORAGE
The handle may be placed in an upright position
for storage.
Move the hairpin cotters to the outer hole on weld
pins. See figure 2. Press inward on the bottom of
the lower handle and push forward. The handle
will lock in this position.
Reverse the above procedure to place the handle
in the operating position.
The handle may be folded away completely for
storage.
1. Remove hairpin cotters from inner hole on
weld pins on handle mount brackets. Place in
outer hole. See figure 2.
2. Loosen the hand knobs on each side of the
handle.
3. Pull inward on the bottom of each side of the
lower handle and push forward.
. 4. Fold the upper handle back and down.
To take the handle out of storage position:
1. Lift the upper handle up and towards the rear.
2. Pull the handle back until it locks into the
operator’s position.
3. Tighten the two hand knobs securely.
4. Move the hairpin cotters to the inner hole on
the weld pins.