MTD 219-381-000 - Manual (Page 7)

b. Hook the barrel end of the cable into the left
hand cable hold-down (K) (black). Slide the
—cable around in the slot as shown in figure 9.
FIGURE 9.
c. Puli the cable upwards to obtain slack, lift clutch
grip, and insert the left hand cable hold-down
into the ieft hand clutch grip. Secure with self-
—tapping screw (M). See figure 10.
d. With the clutch lever released (in the “up” posi­
tion), adjust the bottom nut at the cable bracket
so there is only a slight amount of slack in the
control wire. Tighten the upper nut against the
bracket. Squeeze the clutch lever against the
handle. The control wire should now be straight,
see figure 11.
NOTE
Do not overtighten control wire. Too much
tension may cause it to break.
2. Attach the reverse ciutch cable to the right handle
in the same manner, using the right hand cable
hold-down (L) (brown).
3. Secure the control cables to the handles using
cable ties (N).
4. Trim excess ends of cable ties.
Ai
WARNING
FIGURE 11.
The forward and reverse clutch cable
adjustment must be checked before
the unit is operated as instructed in
the Final Adjustment section on page 8.