Depth stake installation, Assembly of handles – MTD 219-381-000 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Depth Stake
DEPTH STAKE INSTALLATION
Slide the depth stake into the tailpiece to desired depth.
Pointed end of depth stake should face forward. Secure
-with clevis pin (R) and spring pin (S). See figure 3.
FIGURE 3.
ASSEMBLY OF HANDLES
1. Place the handle panel in position on the right and
left hand handles so the tower ends of the handles
bend toward the inside.
2. Secure with carriage bolts (O), lock washers (P)
-------and hex nuts (Q), finger tight only. See figure 4.
3. Remove hex bolt and belleville washer from each
side of frame as shown in figure 5.
4. Place the handle panel assembly in position
against the frame.
5. Start the hex bolt and belleville washer (removed
in step 3) by hand in the bottom hole in handle.
6. Select height position for the handle by lining up
one of the holes in the handle with desired hole
-----in frame. See figure 5.