Note, Hex lock nuts (b), Hex bolts (a) – MTD 112-020A User Manual
Page 5: Figure 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4. Place upper slotted hole of lower handle (K)
over studs located in front of each rear wheel.
Secure with hairpin cotter (G) provided in
hardware pack. See figure 4.
NOTE
It may be necessary to bend the
ends of the lower handle inward
slightly to obtain a snug fit against
the deck.
FIGURE 4.
NOTE
Figure 4 is shown with the rear
wheel removed for clarity. It is not
necessary to remove wheel for han
dle assembly.
-Upper Handle
Halves (J)
^Hex Lock Nuts
(B)
Hex
Bolts (A)'
•V,
5. Assemble the upper handle halves (J) to lower
handle using five hex bolts (A) and lock nuts
------ (B). Only tighten finger tight. See figure 5.
6A. Model 011 Only—Secure upper handle halves
at the top hole using the sixth hex bolt (A).
Hex Bolts (A)
Hex Lock
Nuts (B)
FIGURE 5.
Hex Lock
Nut (B)
6B. Model 020 Only—Place the tab on throttle
control between the upper handle halves at
top hole. Secure with hex bolt (C) and hex
lock nut (B) provided in hardware pack. See
-------figure 6.
7. Tighten securely all six hex bolts and hex lock
nuts with 7/16" wrench.
FIGURE 6. Model 020 Only