Ariens 927 Series - Manual (Page 5)

Decals
CAUTION
Before starting engine
be sure machine is In
neutral and mower
clutch is disengaged.
. e ^ Rt«d operators maouat
« Keep shretds in piace
• Keep people and pets away
GO
• Release parking brake
• Depress clutch pedal
• Shift to 1st or 2nd speed
• Slowly release clutch
e Shift to desired speed
STOP
Depress clutch pedal
Depress Brake ^dal
Selore leaving operator's
position:
Shift to neutral
engage parking brake
Disengage mower clutch
Slop Engine
Remove ignition key
SERVICING
e Wait tor all movement to stop
• Disconnect spark plug wire
• Before Upping unit, dram
gas lank and remove
baltery-ril electric
MaAulactu>*tf Uttav* Nwmbc«s 3139.919 S 3 199 094
Figure 1; Decal Location
Dealer Preparation for Operation
NOTE: All references to “Left", “Right”,
“Front” and “Rear” are given from operator’s
position.
Customer Note; Your Ariens Dealer is expected
to Gornplete these preparation steps and
review important information, including this
manual, with you before or upon delivery of
this unit.
The preparation information is included here
so that you and your dealer may review it
together.
Steering Wheel
Place steering wheel onto column shaft
(lubricate shaft) with holes lined up and drive
roll pin through holes to secure. (Pin should
have equal spacing on both sides of steering
wheel base.)
Seat (RM-928 & RM-1232)
Place seat on seat bracket and install four cap
screws with lock washers. Connect seat
switch wires to connectors. Slide seat to a
safe comfortable operating position and
tighten cap screws to secure seat in position.