Husqvarna 10527STE - Manual (Page 19)

TROUBLESHOOTING
See appropriate section in manual unless directed to a qualified service centre.
PROBLEM CAUSE CORRECTION
Does not start 1. Fuel shut-off valve (if so
equipped) in OFF position.
2. Safety ignition key
is not inserted.
3. Out of fuel.
4. Throttle in STOP position.
5. Choke in OFF position.
6. Primer not depressed.
7. Engine is flooded.
8. Spark plug wire is
disconnected.
9. Bad spark plug.
10. Stale fuel.
11. Water in fuel.
1. Turn fuel shut-off valve to OPEN position.
2. Insert safety ignition key.
3. Refill fuel tank with fresh, clean gasoline.
4. Move throttle to FAST position.
5. Move to FULL position.
6. Prime as instructed in the Operation section of this manual.
7. Wait a few minutes before restarting, DO NOT prime.
8. Connect wire to spark plug.
9. Replace spark plug.
10. Empty fuel tank & catturetor, refill with fresh, clean gasoline.
11. Empty fuel tank & cartjuretor, refill with fresh, clean gasoline.
Loss of power 1. Spark plug wire loose.
2. Throwing too much snow.
3. Fuel tank cap is covered
with ice or snow.
4. Dirty or clogged muffler.
1. Reconnect spark plug wire.
2, Reduce speed and width of swath.
3. Remove ice and snow on and around fuel tank cap.
4, Clean or replace muffler.
Engine idles or
runs roughly 1. Choke is in FULL position.
2. Blockage in fuel line.
3. Stale fuel.
4. Water in fuel.
5. Carburetor is in need of
adjustment or overtsaul.
1. Move choke to OFF position.
2. Clean fuel line.
3. Empty fuel tank & catturetor, refill with fresh, clean gasoline.
4. Empty fuel tank & carturetor, refill with fresh, clean gasoline.
5. Contact a qualified service centre.
Excessive
vibration
1. Loose parts or damaged
augers or impeller.
1. Tighten all fasteners. Replace damaged parts.
If vibration remains, contact a qualified service centre.
Recoil starter
is hard to pull 1. Frozen recoil starter. 1. See IF RECOIL STARTER HAS FROZEN"
in the Operation section of this manual.
Loss of traction
drive / slowing
of drive speed
1. Drive belt is worn.
2. Drive belt is off of pulley.
3. Friction drive wheel is worn.
1. Check / replace drive belt.
2. Check / reinstall drive belt.
3. Contact a qualified service centre.
Loss of snow
discharge or
slowing of
snow discharge
1. Auger belt is off of pulley.
2. Auger belt is worn.
3. Clogged discharge chute.
4. Augers / impeller jammed.
1. Check / reinstall auger belt.
2. Check / replace auger belt.
3. Clean snow chute.
4. Remove debris or foreign object from augers / impeller.
19