General, Storage, Attachments extension tines – MTD 214-100A User Manual
Page 5: Furrow opener
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
10. Tighten bearing cap enough to seal "O" rings.
11. Replace tines and add lubricant.
4. Block tiller legs to raise tires clear of floor. Be sure
tiller is level.
5. Store in a dry, clean area.
General—
Check
periodically
all
nuts
and
bolts.
Loose
nuts
and
bolts
can
cause
permanent
damage
to
your
unit. Keep all nuts and bolts securely tightened.
Storage—
The follov/ing steps should be taken to pre
pare your tiller for storage.
1. Clean tiller thoroughly and lubricate as described
in the preceding instructions.
2. Coat tilling tines with grease to prevent rusting.
3. Prepare engine for storage in accordance with en
gine manufacturer's owner's guide.
ATTACHMENTS
Extension Tines—
This attachment is available to in
crease your tilling width up to 40". Extension tines are
easily
installed
and
removed.
Order
under
part
num
ber 294-162A.
Furrow Opener—
This attachment is easily installed on
the depth bar of your tiller. It can be used for either
furrowing
or
hilling
operations.
These
attachments
are
available through your local dealer.
For
wide
(2"
x
.43")
depth
bar,
order
furrow
opener
294-179A.