Husqvarna 50 Rancher - Manual (Page 4)

CLEANING THE AIR FILTER CHANGING STARTER CORD AND
RETURN SPRING
I ^
^ %
In order to get at the air filter, remove the cylinder cover by undoing
the three retaining screws and lifting the cover off upwards-back-
wards.
Lift off the filter carefully to prevent dirt from falling down into the
carburettor.
Loosen the four screws that retain the starter.
Remove the starter.
Rinse the filter in warm soap suds.
Do not rinse in fuel. Reassemble the filter and make sure that it lies
close to the carburettor. Use two filters alternately. Clean the filter
daily.
Pull out the cord approx. 30 cm and lift up into the notch in the
periphery of the pulley. Zero-set the return spring by letting the
pulley rotate slowly backwards. Undo the screw in the centre of the
pulley. If necessary, remove the return spring and change it.
Lubricate ihe new spring with erigine oil.
Assemble the remaining parts in reverse order of removal.
Lift up the starter cord into the notch on the pulley. Tension the
return spring by turning the pulley clockwise about two turns.
NOTEI
Make sure that it is possible to turn the pulley at least half a
turn further when the cord is pulled out completely.