Ariens SNO-THRO 937 - Manual (Page 7)

Dealer Preparation For Operation
Customer Note: Your Ariens Dealer is expected to
complete these preparation steps and review
important information, including this manual, with you
before or upon delivery of machine or attachment.
The preparation information is included here so that
you and your dealer may review it together.
Engine Fuel
A WARNING: Failure to follow all
instructions could result in personal
injury and/or damage to sno-thro.
Remove wire from spark plug before
attempting any adjustment or assembly
procedure.
IMPORTANT: 2 cycle engines require that oil be
mixed with fuel. Refer to Fuel in Operation Section of
this manual for recommended mixture.
Discharge Chute
Remove rear cap screws and nuts from rear of
discharge chute, tip discharge chute up and install
hardware just removed. Tighten hardware at rear of
discharge chute first then at sides.
Discharge Chute Crank
With discharge chute facing forward, remove engine
cover. With knob down, place Discharge Chute
Crank rod through hole in dash panel and into pinion
on discharge chute. Secure with hair pin. Replace
enginecover.
Handlebar
lock Attach upper handlebar to lower using washers,
washers, lock bars and knobs.
Refer to Adjustments Section and check Attachment
Brake and Clutch for proper function.
Auger Gear Case
Check grease level in auger gear case (refer to
Lubrication and Maintenance Section of this manual).
A
A
WARNING: Gasoline is highly
flammable and its vapors are explosive.
Handle with care. Use an approved
(RED) gasoline container.
CAUTION: Check function of all
controls before starting engine. All
safety devices and guards must be in
position and operating properly or
personal injury may result.
Fill fuel tank with unleaded gasoline and oil mixture.
Tank capacity is 1 quart.
Registration
Complete Sno-Thro Prewarranty Registration Form
and mail original copy to Ariens Company.
Warranty is registered under model and serial
number found on a label on unit.
Delivery
Using the Owner's Manual instruct the customer on
controls and operation of unit. Emphasize safety and
discuss the Safety Precautions.
Explain recommended lubrication and maintenance
of unit.
Advise customer on adjustments.
Explain Ariens Company, Limited Warranty Policy, fill
out Original Purchaser Registration Card, Parts and
Repair Manuals order Form and return to Ariens
Company. Place Model and Serial Number on page
(1) of this manual.
Give customer his Owner's Manual and advise him to
thoroughly read and understand Sno-Thro Owner's
Manuals.