Darning and embroidery – SINGER W120 User Manual

Page 20

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

DARNING AND EMBROIDERY

Raise the presser bar lifter and remove the presBei. foot. Then lower the presser

bar lifter to ensure the thread tension device is set correctly.

Set

the drop feed knob at "O",

Now your machine is ready for embroidery and darning.

Embroidery will be done most successfully when the fabric is stretched and fixed in

an embroidery hoop. Hold the hoop closely on the machine bed with both hands, press

the material with your left forefinger in the vicinity of the needle.

This will help in holding down the material and will prevent the machine from

making skipped stitches. Manipulate work carefully and be sure to keep fingers out

of the path of the needle.

Adjust thread tensions for the best appearance of embroidery work and slightly in

crease the bobbin thread tension to avoid the lower thread from being pulled up.