Preparino to sew – SINGER WK-100 User Manual

Page 9

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

10. PREPARINO TO SEW

Fig. 18

. Hold the loose end of the needle thread

in your left hand, and turn the fly

wheel toward you by hand until the

needle moves down through the needle

plate and up again to its highest position.

Pull the needle thread gently, and the

bobbin thread will come up with it

through the hole in the needle plate.

Then place both ends of the thread
back between the toes of the presser foot.
N O T E : If the bobbin thread does

not rise, check to see if there is at
least 3 or 4 inches of bobbin thread
hanging loosely from the bobbin case.

2. Pull the two threads at least 5 inches

behind the presser foot. Place material

under presser foot, and lower the foot

with the presser bar lifter. Regulate

the stitch to the desired size and sew.
TO REMOVE MATERIAL, raise the

needle to its highest position and raise

the foot with the presser bar lifter, then

pull the fabric back and to the left.

Cut the thread with the thread cutter

behind presser bar. leaving a few inches

of thread behind the presser foot.

Fig. 19