Maytag 8111P375-60 - Manual (Page 16)

ABOUT YOUR RANGE
OVEN LIGHT
CAUTION
Disconnect power to range by tripping circuit
breaker or removing fuse before replacing light
bulb.
Be sure bulb is cool before touching or replacing
bulb.
Use a dry potholder to prevent possible harm to
hands when replacing bulb.
Do not touch hot bulb with a damp cloth as this
may cause the bulb to break.
To turn on the oven light: Push in
rocker switch located on the backguard.
To replace oven light buib:
1. Disconnect power to range.
2. Hold bulb cover in place then slide wire retainer off
cover. NOTE: Bulb cover will fall if not held in place
while removing wire retainer.
3. Remove bulb cover.
4. Remove light bulb and replace with a 40 watt appliance
bulb.
5. Replace bulb cover and secure with wire retainer.
6. Reconnect power to range. Reset clock.
BULB COVER
OVEN RACKS
CAUTION
Do not attempt to change the rack position when the
oven is hot.
The oven rack is designed with a safety lock-stop position.
This prevents the rack from accidently coming completely
out of the oven when pulling the rack out to add or remove
food.
To remove oven rack:
1. When rack is cool, pull rack straight out until it stops at
the lock-stop position,
NOTE: If it is necessary to change rack position when
rack is hot, use potholders to protect hands.
2. Tilt the front end of the rack up.
3. Continue pulling rack out of oven.
To replace oven rack:
1. Place rack on the rack supports in oven.
2. Tilt the front end of the rack up slightly.
3. Slide rack back until it clears the lock-stop position.
4. Lower front of rack and slide rack straight back into
oven.
5. IMPORTANT: Pull rack out to the lock-stop position to
be sure rack is correctly replaced.
6. If properly installed, rack will not come out of oven
unless the front edge is lifted up.
7. Push rack back into oven and close oven door.