SINGER W1407 - Manual (Page 39)

PART III CARING FOR YOUR MACHINE
CLEANING FEED DOG AND SHUTTLE
Lever Lever
Shuttle Assembly
Shuttle Race Cover
Pointed
hook Shuttle
Fig. 1 Cleaning the feed dog with a
brush.
To insure the best possible operation
of your machine, it is necessary to keep
the essential parts clean at all times.
Using a small brush, remove the lint that
accumulates in the........shuttle area and
around the feed dog.
Fig, 2 Parts of the Shuttle Assembly
To Clean the Shuttle Area:
1. This area must be kept free of dust,
lint and occasional tangled thread.
Raise the needle to its highest
point and remove the bobbin case.
2. Push levers of shuttle race aside and
lift shuttle race cover and shuttle out.
3. Clean the shuttle race with small
brush.
4. Put a drop of oil on the center pin of
the shuttle and shuttle race. Isee
■ arrows).
To Replace Shuttle Assembly:
1. Position shuttle race as illustrated so
that race is forming half moon on
the left side of the machine.
2. Hold shuttle by center pin and posi­
tion shuttle so as to form a half moon
on the right side. Pointed hook will
be on the bottom.
3. Place shuttle race cover into place
over shuttle assembly.
4. Snap the levers into position.