Maytag 12001736 - Manual (Page 3)

FRONT PANEL NOiSE:
1. Disconnect electrica! power to washer.
2. Remove the front panel of the washer.
3. Locate the package containing the two plastic
plugs in the kit. Press the plugs into the flange of
the cabinet. (Figure 2}
The plugs will bow the front panel slightly, thus
stiffening the panel and eliminating panel
vibration.
4. Locate the two "U" nut tinnermans in the kit.
5. Remove the two screws securing the "J" clips to
the baseframe. (Figure 3}
6. Position the "U" nut tinnermans onto the
baseframe over the two screw holes.
7. Remount the "J" clips to the baseframe by
screwing into the "U" nut tinnermans on the base
frame.
CABINET TO BASE NOISE:
1. Disconnect electrical power to
washer.
2. Remove the front panel of the
washer.
3. Locate the package containing the
six small foam pads in the kit.
Loosen the screws securing the
cabinet to baseframe.
4. Insert a foam pad between the
inside of the cabinet and the
baseframe and retighten the
screws securing the cabinet to
baseframe. {Figure 4)
TS647 Pages