SINGER 3102 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4. Place thread spool on spool pin over the
felt. Lead thread around bobbin winder 7.
tension disc and through small hole in
bobbin ffrom inside out).
5. Place bobbin on spindle and move bob-
bin-winder lever to right.
B.
6. Hold thread end and start the machine.
Cut off thread end after a few coils have B.
been wound.
^Hhen required amount of thread has been
wound (winding will stop when bobbin is
full) stop machine and cut connecting
thread.
Move bobbin winder lever to the left and
remove bobbin.
Hold hand wheel and tighten hand wheel
knob.
I.
Hold bobbin so that thread unwinds in
direction shown» and insert bobbin in
bobbin case.
2. Pull thread into notch A in bobbin case,
draw It toward left and into slot B.
3. Draw approximately four inches of
thread diagonally across the bobbin.
Close slide plate, allowing thread to ex
tend through the slot between the slide
plate and the needle plate.