SINGER W431 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1. Take-up
2. Pressure Control
3. Top Thread Guides
4. Stitch Selector
5. Creative Embroidery
Control
6. Stitch Width Control
7. Bobbin Winder
8. Hand Wheel
9. Stitch Length Control
10. Reverse Button
11. Bobbin Winder Tension
Discs
12. Feed Dog Height
Control
13. Needle Plate
14. Presser Foot
15. Slide Plate
16. Thumb Screw
17. Check Spring
18. Face Cover
19. Tension Control
20. Needle Clamp
21. Spool Pins
22. Light Switch
23. Presser Foot Lever
24. Thread Cutter
25. Feed Dog
26. Head Hinge Holes
27. Motor
28. Belt Cover
29. Clutch.Nut
Always at its highest position when beginning or ending
iiewing. .
For regulating the pressure on fabric.
For leading thread to tension control for sewing
sej^tjng one of four different groups of utility stitch.
|e adjustment of zigzag, stitch Width as well as
■..Eor wtiing stitch width and buttonholer
iFof wiriding thread on bobbin.
For the control of the up and down movement of the
needle.
For selecting stitch length between no feeding and
about 6 stitches per inch.
For easy backtacking to lock thread ends.
For providing proper tension on thread when bobbin
winding.
For regulating feed dog height for various materials and
types of sewing.
With guide lines for sewing accuracy.
For holding fabric when sewing.
For opening an access for bobbin and bobbin case.
For tightening presser foot in place on presser bar.
For automatic precise adjustment of flow of upper thread.
Hinge-open type for replacement of light bulb and oiling.
For regulating the arhount of tension on upper thread.
Forholding needle in place in the slot of needle bar.
Fprhpjding spools, preventing over-spin of spools.
For turning on or off the light inside face cover.
For lifting or lowering presser bar and presser foot.
For convenience to cut both upper and lower threads
after sewing.
;
'
•iDiambhd boint to move fabric accurately.
For installation of machine head onto portable case or
cabinet.
110 — 115 Volts, for running machine.
For covering motor belt.
For releasing movement of the needle bar in order to wind
;bobbin.j' ,